RAM is your computer’s temporary memory. It’s where you store your data so you can access it later. A lot of RAM is necessary for a computer to run well, so having enough is important.
If you’re having trouble getting your laptop to start up after you’ve installed a new memory module, there are a few things you can do to try and fix the problem. First, make sure that the new memory module is properly seated in the laptop’s motherboard. Next, check to see if your computer is booting properly by pressing the power button and then selecting “start” from the menu that appears. If your computer is still not booting after installing the new memory module, try restarting your laptop in Safe Mode by pressing and holding down both the power button and the reset button at once until you see a message onscreen telling you to release both buttons. ..
Ways to fix your Laptop Not booting after RAM upgrade
Reinstall the RAM
Turn off the computer and disconnect it from the power source.
Remove RAMs from your computer so that you can save power and improve performance.
The computer is installing the new RAM, but it is not working.
Check the maximum RAM capacity
Type “cmd” and press enter. Type “netstat -an” and press enter. The output will show the active network connections on your computer.
In Windows Terminal, paste the code below and press Walk. ..
To find out the maximum capacity of a hard drive, you can use the WMI command “memphysical.” ..
The script displays the maximum RAM capacity in kilobytes. ..
If you are trying to install a larger amount of RAM on your computer, try installing a smaller capacity.
A power reset
Remove the power cord from the PC.
Some computers have a coin-cell battery that needs to be removed in order to start the computer. This varies by computer, so be sure to check the manual. ..
Press and hold the computer’s Power button for 20 seconds, after which you release it.
If your PC has a coin cell battery, it may be time to replace it. ..
Plug your computer’s power cord into a power source and restart your computer. ..
Final Words
If your laptop won’t start after upgrading its RAM, it may be because of a damaged motherboard or one of the computer’s delicate internal components. To fix the issue, follow these simple steps:
- Open up the PC and remove any old RAM if there is any.
- Place new RAM in the PC and close it down completely.
- Turn on the PC and wait for it to boot up.
- If the laptop still won’t start, you may need to take it to a service center or repair shop for help.
